If you want to see more pictures of our 3D panel house project all
over the world, please refer: http://www.hbhscn.com/project_nc8
What is the benefit for 3D panel building system?
2.Simple installation,shortening of construction time
3.Thermal and sound insulation
4.Durable or low-maintenance
6.Recycled green products
7.Fire & Moisture proofing
8.Hurricane & Earthquake protection
EPS 3D panel Installation
1.Install 3D wall panel
Install rebar on foundation beams, floor slabs, columns and beams,
where the panels are to be installed. The rebar are installed in an
alternating (zigzag”) pattern. For steel structures, the rebar are
welded onto the steel beams and columns.
②Attach the 3D panel together
Prepare panels according to plan drawings, or trim panels if they
arrive in modular typical sizes, according to the needs. Tie the
panel onto the rebar using tie wire.
Window & Door
The opening of window and door should be cut well before install
the wall panel.Install cross braces on each corners of door and
window openings, on both side of the panels. Mount U-mesh around
the perimeter of door and window openings.
Install U” type mesh or Angle” mesh at each corner at full length
of the corner on both inner and outerside. The angle mesh service
as additional bracing to allow corner to function as columns after
concrete is applied.
Support braces and alignment
Install supports, and perform alignment for the panels, so they are
installed straight and each plane is perpendicular to each other.
⑥First plastering and guide installation
Apply first layer of concrete on both side of the panels, using
shotcrete machine. Afterwards, install guidance to ensure
consistent thickness of the second (final) layer of plaster.
Apply the second layer of plaster, then smoothen the surface using
Wall is ready for finishing by skim coat or paint.
2.Install 3D panel slab, floor panel, roof
①Installation of scaffolding and formwork
Install scaffolding and prepare formwork. If desired, fenolite
sheeting can be applied at this stage.
②Panel and beam reinforcement installation
Place panels on top of formwork, tie them to installed rebar,
insert steel reinforcement into the trenches on floor panels.
Cast the void between formwork and the panels with concrete mix
without aggregate, by concrete mix with aggregate for topping up
and filling of the reinforcement trenches.
Screed surface until perfectly level. Afterwards, surface can be
used to mount tiles, carpet, etc.
About 3D wire mesh panel, and 3D mesh panel machine, pls refer the
3D panel production line, pls refer
3D panel, pls refer http://www.hbhscn.com/3d-panel_p41.html
3D panel fence, pls refer
Zig zag type 3D panels, pls refer
Welded mesh machine, pls refer
Vertical type 3D panel machine, pls refer
Horizontal type 3D panel machine , pls refer
Raw material and tools about 3D panel house, pls refer
EPS 3D panel machine manufacture workshop, pls refer
EPS 3D panel machine container loading pictures, pls refer