DE Series firing system worked by110/220VACor12/24V DC. It has the “test” function. Each channel could fire about 20pcs igniters if by AC,
about 10pcs igniters by DC. This series firing system could “salvo fire”,“sequential fire” and “step by step fire”.Time range is from0.1-9.9s. It can beremote and manualcontrol.
Connect & Test
1. Please put the power plug of firing system into 220V/110V AC, or
connecting DC by DC plug on machine.
2.Please turn on the power switch, then move the button to“test”position. If the power lamp light and time table shows:9.9s.It
indicates the system is in good condition.
3.Please connect the products into black & red clip. There are
LED for each channel. If the LED turns red. It indicates that
products are connecting well. It’s very easy for“test”
4.Please move the button to“fire”position, then you can fire.
Salvo fire & Sequential fire
1.Salvo: The time table shows: 9.9s when the power was ready. After
you press button”time”one time, the time table will change to 0.0s. Please press”salvo”button now.
2.Sequential: Once you press the“time”button one time, the sequential time will add 0.1s. When it is
adjust to the time that you need , please press“rapid”button , it will make firing system sequential fire. If you need
reset sequential time, please cut off the power for about 2
3.Step fire: Please make sure that the time table shows0:0. Then please press“step”button or“1.2.3”button one by one. Both way will make it fire step by step.
4.Number of cues: What the time table shows is the sequential cue
numbers during the sequential fire.
1. Please don’t make it to be short circuit for that would damage
2. If connecting products in series, Because the resistively of
ignition dissimilarity from different factory , please use the
products which made by the same factory;
3. Please turn off the power switch when the circuit connecting but
no need use it , and notice to do not shake machine violently;
4. Don’t press “FIRE” after pull out electrical outlet, for there
is left power would ignite products;
5. Please don’t place the product in the damp , sour ,alkali and
Accessories & Parameters
Remote frequency : 433MHZ
Remote battery: 23A
Safety switch for “test”and “fire”
Please move the switch to the “Remote”position. The transmitter is
divided into A and B parts. Please move to “A”position to run 12
channels in A part. The same with “B”part.