Parker Chelsea 14750152H Dump Truck Valve FBH34-12 5 hole Dump
Tipper Air Control Valves are designed to enable easy controls of
hydraulic functions as well as controlling air from the cabin of
These are manufactured by adhering to preset industry norms and are
compatible with makes of major vehicle manufacturers.
1) Power: Hydraulic
2) Material: Aluminum
3) Automatically locked in stop and fall position
4) Working medium:Air
5) Operating pressure(Bar): up to 12
6) Working temperature: -40℃-/+80℃
7) Nominal diameter(mm) 4
8) Weight: 0.6kg
1.Body Material: Aluminum
2.Seal Material: HNBR
3.Working Pressure: 0.5-12 Bar
4.Ambient temperature: -55℃-180℃
5.Port Size: M10*1
6.Automatically locked in stop and fall position
8.Able to coordinate with the Pneumatic control valve
9. Small Operating force
11.Easy to install
12..Long service life
Mounting of the air control:
When the air control is mounted next to the drivers seat a strong
support should be used.
Available supports are:
- 092 32 002 for on-seat mounting
- 092 05 002 for on-floor mounting
Use always rubber grommets to protect air tubes and to prevent that
dust and water enters the cabin.
For trouble free life of the entire pneumatic system the air system
must be free from water.
The air control should be mounted in such a way that:
1 it is easy to reach by the operator.
2 it is no obstacle when entering or leaving the cabin.
3 it is clear from any moving parts such as drivers seat and closed
The air exhaust connection must be brought outside the
cabin to prevent air entering the cabin, which gives the following
2 blown up sand and dust
3 when alcohol is used to prevent the pneumatic system against
frost the alcohol vapour will enter the cabin
o Make sure that air tubes:
1 are not too close to sharp objects.
2 are clear from moving parts.
3 are clear from exhaust and compressor lines.
4 can not get kinked.
5 are not too long.
note: The air supply must always be tapped off from a accessory air
tank or auxiliary valve and the
pneumatic system must be protected with a charging valve.
( see guide - lines from truck manufacturer )
For operation of the air control see the Hyva
operation and maintenance instructions
The air supply must always be taken from an accessory air tank or
auxiliary valveand the pneumatic system must be protected with a
|Our product features:||Our Services Guarantee:|
|1) Competitive price||1) Prompt respond (Reply with 24 hours)|
|2) Good quality||2) Free Samples (Customer pay for the delivery cost)|
|3) Professional Packaging,||3) Registration support.|
|4) Produce according to Customers’ instruction||4) Photos/videos are available during production.|
|5) None delay shipment|
5) Loading inspection, and send loading photos before shipment.
Quality Standards :
The company for the products are brand new original products, no
second-hand and refurbished products, or leave a compensable ten
and return the full amount , but the buyer due to our purchase of
model error is not responsible for returns, another of the
company's sales of products enjoy one year from the date of
shipment quality assurance , according to the original quality
standards , during warranty with product problems , need
confirmation testing by the manufacturer , the supplier to be
solved , the demand side due to storage , use, poor maintenance
caused by lower-quality product , and not raise objections
All item Comes with Basic 3 Month Sellers Warranty, if item
defective in 3 Month, We will offer replacement without extra
Charger(including shipping fee)After we Receive the Defective item.
If item Defective after 3 Month, Buyers can still send it back, We
will contact suppliers or Manufactory for Warranty. Buyers Might
Need to pay the Shipping fee For resend the replaced item.