HXE-400/13DL Large Copper wire drawing machine with annealer
HXE-400/13DL Large copper wire drawing machine with annealer is
used to draw and anneal single bare copper wire from 8mm to
1.2mm-3.5mm.The drawing capstans are arranged in a line that are
able to work continuously with drawing speed and electrical control
can be matched with each other.
II. Compositions of equipment
|1. Pay-off shelf||1|
|2. HXE-400/13DL Main drawing machine||1|
|3. HXE-TH450 Annealing machine||1|
|4. HXE-180 Tension controller||1|
|5. HXE-SX500/630 Double spoolers||1|
|6. HXE-WF750 Coiler & Basket changer system||1|
|7. Electrical cabinet||1|
|8. Gear Oil Cooler and Pump||2|
|9. Operation panel / With PLC&Touching screen||1|
|10. Spare parts|
III. Main technical parameters
|3. Diameter of capstans||400mm|
|4. Speed||1000m/min, Capacity say 1.2mm, 600kg per hour|
|5. Slip ratio||1.238|
|6. Quantity of capstan||13|
|7. Capstan||Tungsten carbide|
|8. Quick dies change||Available|
|9. Main motor||DC 200KW|
|10. Fix speed motor||DC 55KW|
|11. Gear||Not Changeable|
|12. Noises of machine||≤85 db|
|13. Protection cover||Installed|
|14. Lubrication system||1 set|
4-1. If wire breaks, will stop automatically, and the Fault
Indicator light will open.
After connect the wire, press the Fault Reset button(Yellow button)
and the On button (Green button), to run the machine again.
4-2. Press Emergency Stop button(Red button) to shut down the
After solve, press the button again to run the machine.
4-3. After set the Length-counter, the machine will stop
automatically when reach the length set.
After change the Spool, please press the Length Reset button(Yellow
button) and the Spool Reset button(Yellow button) to run the
4-4. After the machine stop(no running at all), then switch the
Pump switch to stop the lubrication.
4-5. Do not touch the wire in the Annealing section.
4-6. After shut down the machine, need at least 30 seconds to
restart the machine.
4-7. Wire often breaks, adjust the speed, balance arm, check the
dies are clean or not.
4-8. If has scratch on the surface of the wire, check the capstans
on the Take-up part. Check the drawing capstans.
V. Machine maintenance and precautions
1. Make sure the machine and the capstans clean, no scrap, no break
2. Make sure the Take-up part clean.
3. Electrical cabinet should be closed.
4. Change belts if worn out.
5. Only qualified electrical technician can repair the electrical
6. Never change the Inverter parameter.
7. If something wrong with the machine that can`t solve, please
contact the supplier first.
Do not open the machine without consulting to the supplier.
8. Put lubrication oil to the parts regularly, to make sure all
parts running fluently. After running 1000 hours, clean all the
9. Annealed nickel belt and Annealing carbon brush are consuming
parts. If spark happens a lot on the annealing capstans, then
should change the nickel belt. If the carbon is going to run out,
then need to change a new set.